TP-Link TL-MR3420 Wireless N Router with 3G QSS Configuration By PIN

Category : TL-MR3420

If the new device supports Wi-Fi Protected Setup and the PIN method, you can add it to the network by PIN with the following two methods.

Method One: Enter the PIN into my Router

Step 1: Keep the default QSS Status as Enabled and click the Add device button in Figure , then the following screen will appear.

TP-Link TL-MR3420 Add A New Device by PIN

Step 2: Choose Enter the new device’s PIN and enter the PIN code of the wireless adapter in the field behind PIN in the above figure. Then click Connect.

Note:
The PIN code of the adapter is always displayed on the QSS configuration screen

Step 3: For the configuration of the wireless adapter, please choose Enter a PIN into my access point or a registrar in the configuration utility of the QSS as below, and click Next.

TP-Link TL-MR3420 The QSS Configuration Screen of Wireless Adapter - Enter PIN

Note:
In this example, the default PIN code of this adapter is 16952898 as the above figure shown.

Method Two: Enter the PIN from my Router
Step 1:
Get the Current PIN code of the Router in Figure (each Router has its unique PIN code.
Here takes the PIN code 12345670 of this Router for example).

Step 2:
For the configuration of the wireless adapter, please choose Enter a PIN from my access point in the configuration utility of the QSS as below, and enter the PIN code of the Router into the field behind Access Point PIN. Then click Next.

TP-Link TL-MR3420 The QSS Configuration Screen of Wireless Adapter - Enter my PIN

Note:
The default PIN code of the Router can be found in its label or the QSS configuration screen as Figure

c). You will see the following screen when the new device successfully connected to the network.

Note:
1) The status LED on the Router will light green all the time if the device has been successfully added to the network.

2) The QSS function cannot be configured if the Wireless Function of the Router is disabled.
Please make sure the Wireless Function is enabled before configuring the QSS.



Share

Post a comment